AIR802 PASSPOE-03 Passive PoE Injector/Splitter with 3.5 mm x 1.35 mm DC Size Connector

AIR802 PASSPOE-03 Passive PoE Injector/Splitter with 3.5 mm x 1.35 mm DC Size Connector



AIR802 PASSPOE-03 Passive PoE Injector/Splitter with 3.5 mm x 1.35 mm DC Size Connector Feature :

3.5mm x 1.35 mm jack / plug splitter kit

Allows use of any DC voltage up to 60 vdc

Use with IP security camera, wireless access point and other devices

Commonly used with Foscam brand cameras

AIR802® has developed a passive Power-over-Ethernet (PoE) kit or set that allows low cost of delivering power over the network cable for shorter distances. This scheme allows power to be carried on 10/100 networks over the spare, unused pairs of a CAT5, CAT5E, or CAT6 Ethernet network cable. On shorter network lengths, the source power could be the power supply that came with the wireless access point, IP video surveillance camera, etc.
This set contains a very cost effective injector and breakout or splitter component. The injector inserts the DC voltage at the source location into the 5.5mm x 2.1mm injector plug. The DC voltage is then carried over the spare pairs of the 10BASE-T or 100BASE-T network cable. The breakout or splitter extracts the DC voltage from the network cable onto the 5.5mm x 2.1mm splitter jack. Two other models are availabe which have different DC size connectors: model POEPASS-01 (5.5 x 2.1 mm) and POEPASS-02 (5.5 x 2.5 mm). and POEPASS-03 (for Panasonic products)

This model is commonly used with Foscam model cameras. Foscam cameras come with 5vdc power supplies. Voltage drops or dissapates naturally over ever foot of cable used. The precise amount of the voltage drop depends on variables like the cable length and quality. There is an abundance of poor quality cable in the market, including patch cords. It is too complex to fully describe here but in general the AWG (size) of the conductor is mis-stated (smaller than than specified) or it may use copper cladded aluminum instead of solid copper as the conductor. Purchase only cable with valid UL safety and ETL-Verified performance to the TIA 568-B specifications. Visit the AIR802 website, see the UL and ETL logos, click and see these organizations online directories of compliant manufacturers. Note that Foscam cameras will not work less than 4.5 vdc. Exceeding 1/2 volt loss causes the camera not to operate. Insure quality cable and many are using a higher output power supply, i.e. 6vdc.